Laundry front loading washer displaying Error Code LOC control lock activator.
Issue
- Laundry washer displays Error Code LOC.
- Control lock activator signal.
Applies to
- Front loading laundry washers.
Solution
Error Code LOC indicates that the control lock is being used to lock the controls between cycles. Note: Use this feature to reduce the likelihood of accidental operation by children.
Troubleshooting
- Scroll to the control lock option and press select.
- The control lock icon will show on the LED display.
- To unlock the controls, scroll to the control lock option again and press select.
- Washer cycles will not run when control lock is activated.
IF YOU WERE UNABLE TO RESOLVE YOUR ISSUE
- For units installed within the past 30 days, please refer back to your installer to resolve this issue.
- For units installed after 30 days please contact us to schedule service.
Was this article helpful?
Related Articles
- How to Clean & Care For Your Front Load Washer
- What should I do if my washer does not start?
- Laundry front loading washer displaying Error Code E42 door lock device failure.
- Laundry front loading washer displaying Error Code E11 long fill time.
- Laundry front loading washer displaying Error Code SU dS too many suds.
- Laundry front loading washer displaying Error Code E21 long pump out time.
- Laundry Washers Noises Guide
- Laundry Water Supply Guide
- Laundry front loading washer displaying Error Code E35 pressure sensor indicates water overfill.
- Laundry front loading washer displaying Error Code E41 door is open.