Laundry front loading washer displaying Error Code HO SE reversed hose detection.
Issue
- Laundry washer displays Error Code HO SE.
- Problem with hot and cold water switch.
Applies to
- Front loading laundry washers.
Solution
Error Code HO SE means condition is detected where the inlet hoses have been installed incorrectly (hot supply to cold inlet and cold supply to hot inlet), the washer will alert you.
Troubleshooting
- Note: Make sure you turn off the water first.
- LED will display “HO” followed by “SE” and then the remaining cycle time (0 min) for 60 seconds and then repeat.
- Press the cancel button.
- Shut off each water supply valve and attach each supply hose to the correct inlet connection on the washer.
IF YOU WERE UNABLE TO RESOLVE YOUR ISSUE
- For units installed within the past 30 days, please refer back to your installer to resolve this issue.
- For units installed after 30 days please contact us to schedule service.
Was this article helpful?
Related Articles
- How to Clean & Care For Your Front Load Washer
- What should I do if my washer does not start?
- Laundry front loading washer displaying Error Code E42 door lock device failure.
- Laundry front loading washer displaying Error Code E11 long fill time.
- Laundry front loading washer displaying Error Code SU dS too many suds.
- Laundry front loading washer displaying Error Code E21 long pump out time.
- Laundry front loading washer displaying Error Code LOC control lock activator.
- Laundry Washers Noises Guide
- Laundry Water Supply Guide
- Laundry front loading washer displaying Error Code E35 pressure sensor indicates water overfill.