Laundry front loading washer displaying Error Code E35 pressure sensor indicates water overfill.
Issue
- Water runs continuously.
Applies to
- Front loading laundry washers.
Solution
Error Code E35
Error Code E35 indicates the washing machine pressure sensor is Indicating water overfill.
Troubleshooting
- NOTE: This is a known installation issue. If your washer was recently installed or moved, have the installer verify the installation was done correctly.
- Pressing cancel will cause the Error Code E35 to disappear from the display, then resume cycle by pressing start.
- Perform a hard reset by disconnecting the AC power cord, re-connect then wait a couple seconds until cycle ends or beeps. Then restart the cycle.
IF YOU WERE UNABLE TO RESOLVE YOUR ISSUE
- For units installed within the past 30 days, please refer back to your installer to resolve this issue.
- For units installed after 30 days please contact us to schedule service.